HOW TO INSULATE A GARAGE DOOR?

Share on pinterest
Share on facebook
Share on twitter
Share on linkedin

How to insulate a garage door? Garage door insulation is quite necessary for you. Energy cost is increasing with each passing way.
To keep the heating and cooling costs in check, insulating is essential.
When attached to your home, the garage can be a source of energy loss.
It can be a weak link to the thermal envelope of your house.
Hence, insulating the garage door is necessary.
An insulated garage door will save energy regulate temperature.
It will keep your garage from becoming too hot in summer and freezing in winter.
Besides, they are much thicker, heavier, and much more energy-efficient than uninsulated ones.
If you have the garage is connected to your home or you have many elements there and spend time inside, you must have them insulated.

Here, we will discuss how to insulate your garage door.

Benefits of garage door insulation

  • Reduce energy levels
  • Boost thermal efficiency
  • Prevents garage door draughts
  • Reduce carbon emissions
  • Reduces outside noise entering the house

Steps to insulate a garage door

Measuring and marking, installing the retainer pins

Take a tape measure to measure the spot that is 12inches away from each side of the garage door panel and midway between the horizontal rails. After measuring, put a mark on the spot.
The markings must be centered vertically.

Now, peel off the adhesive backing paper from the retainer pins.
Press its base on the panel.
On each marking, continue the same process.

Cutting the foam board insulation

Cut the insulation material you will be using for the garage door. There are pre-cut foam core panels available too. Spread the material on the ground with the vinyl side facing downwards.
Measure the foam using the tape and mark the spots. Remember, panel lengths can vary.
So, measure all the panels separately first.
Place the insulation on a solid, stable surface area and compress the panel using a straightedge.
Cut it out with a knife.

Also Read: Common garage door problems

Locking the cut insulation in place

After you have the proper length of the foam cut board, center the insulation against the panel push it towards the retaining pin so that it pierces the vinyl surface.
As the retainer pin pierces them, start pushing the insulation deeper in place using the retainer cap.
Keep doing it until it snaps into place. As you secure it, repeat the process on each panel of your garage door.

Framing the doorstop using a weatherstrip

Angle the weatherstrip at 45 degrees to test fit the doorstop. Then pound nails into the side pathway and secure it.

Installing a new bottom seal

As you complete insulating and securing your garage door, you come to the end part of the process. The old bottom seal tracks have to be removed. Using a flathead screwdriver, bend it out of that place. Repeat the process on both sides to remove it completely.

Putting the new bottom seal in place

After removing the old bottom seal, use silicone or detergent and spray in the bottom slots. Put on the new seal in place along the bottom of the insulated door.

Wrapping Up

After you complete your Garage door insulation, check if it is properly balanced and working smoothly. If you face any problem you can contact garage doors services like Nevada Garage Door Repair for quick and efficient service.

Share on pinterest
Share on facebook
Share on twitter
Share on linkedin

Leave a Comment

Your email address will not be published. Required fields are marked *

Related Articles

emergency

We're here to help! Call Us Today!

footer_address_icon

Address

9657 Marbel Peak Ct,
Las Vegas, NV 89129

footer_phone_icon

Call Us

(702) 710-2247

footer_working_hour_icon

Working Hours

Sun - Fri: 24 hrs
Saturday: Closed

Scroll to Top